Natural remedies and chemical solutions to say goodbye forever to stains caused by humidity and infiltrations

Smelly and with unsightly yellow and greenish stains: everything can be said about mold in the home except that it is a spectacle for the eyes or smell. The reasons that lead to its formation are many: old walls, poor air renewal, excess humidity, defects in insulation works or water infiltration. However, whatever the cause, once it appears, immediately focus on eliminating it. The risk of developing allergic reactions due to  bacteria. Already the spores spread through the air, in fact, is higher than ever. So the first step might be to eradicate what caused it so you don’t have to deal with it a second time. Once this is done, however, it is necessary to clean the surfaces: let’s see how to remove mold from walls with some effective remedies.

White vinegar is a powerful mold remover

Among the most effective natural solutions to eliminate mold from the walls of the house is undoubtedly white vinegar: the acid it contains, in fact, manages to sterilize the surfaces on which it is applied and perfectly clean the walls of any trace of mold. dirt. A good way to use it, therefore, is to add a few tablespoons to a spray dispenser filled with plain water: doing so will make it easier to spray the solution directly onto the wall to be treated. Once this is done, however, it is necessary to let the liquid act for a few minutes before wiping it with a soft cotton or microfiber cloth and continuing to rub until the mold is completely removed. Where the  stains were particularly stubborn, however, it is possible to proceed with the white vinegar used in purity, remembering to keep the windows open so as not to permeate the room with its strong smell.

Baking soda and lemon to remove mold

Still remaining in the field of natural remedies, an alternative to vinegar can be the combination of baking soda and  lemon  : together, in fact, these ingredients give life to a powerful detergent capable of counteracting even the most persistent fungi. In addition, both have a deep antibacterial and  whitening action  , perfect for removing stains from walls without damaging the plaster.

Its use is very simple: always starting from a spray diffuser, just dissolve two or three tablespoons of baking soda in water and add the juice of one lemon; for an even stronger solution, you can also pour a tablespoon of vinegar; Finally, dropping a few drops of  scented essential oil  will allow you to better resist the intense odor generated, especially if the environment to be treated is small or without windows.

Hydrogen peroxide against stains

Let’s now move on to chemical remedies: one of the most effective is undoubtedly hydrogen peroxide, which, however, precisely because of its aggressiveness, should be diluted in a little water. The addition of baking soda, then, enhances its whitening action; With salt, on the other hand, you obtain a solution capable of attracting moisture from the wall, making the risk of the mold problem recurring much more remote. The method of use is always the same: a few drops sprayed directly on the wall and a soft cloth to rub and collect impurities. Finally, if necessary, it is possible to repeat the operation until the result is perfect.

Remove mold with bleach

Whether the mold is in the bathroom, living room, kitchen or bedroom, another excellent solution for removing mold is bleach: a detergent with strong whitening power that, if used correctly, removes stains without damaging the walls. In this case, the steps to follow are as follows: start by filling two buckets with warm water and add the appropriate amount of product to one of them; after which a large sponge can be dipped into the container with the bleach before rubbing the entire area to be treated; This last step can be done over and over again, until the  mold is completely removed; Now all you have to do is use a second sponge moistened in the sink with just water to thoroughly clean the entire surface and thus obtain a shiny, like-new wall.

Regardless of the method you have decided to use, finally, a good idea is to paint the walls of the room with  specific anti-mold paints  : these can be purchased at the most stocked home improvement stores, or you can order them from professionals hired to carry out the ‘operation.